MXR M89 Bass Overdrive [mint] / Seymour Duncan Paranormal [new] (Inwood / Wash Hts)

MXR M89 Bass Overdrive [mint] / Seymour Duncan Paranormal [new] 1 thumbnailMXR M89 Bass Overdrive [mint] / Seymour Duncan Paranormal [new] 2 thumbnailMXR M89 Bass Overdrive [mint] / Seymour Duncan Paranormal [new] 3 thumbnail
condition: like new
MXR M89 Bass Overdrive
Mint in box - $80

Seymour Duncan SFX-06 Paranormal Bass EQ DI
New in box - $110

DI with active three-band EQ
The three-band EQ allows you to dial in your tone in any room, sculpting your lows, mids, and highs quickly and easily. So, along with performing the normal functions of a DI, you get the benefit of adding an active EQ to your bass without having to make any modifications to your instrument. The EQ provides ±12dB boost and cut for each band, which have center frequencies at 30Hz for deep lows, 650Hz to contour the mids, and 5.2kHz for presence, clarity and attack.

Proprietary Slap Contour switch for happy slapping
The SFX-6 also features Seymour Duncan's proprietary Slap Contour switch, which applies an additional preset EQ curve. As the name implies, this is a dedicated switch for slapping styles, but it also adds an extra dimension to fingerstyle or pick playing. Slap Contour gives you a 6dB boost at 80Hz to bring out the bottom and cuts 6dB at 650Hz to reduce the mud that can occur in the low mids. The result is a solid low end and more room for attack. By using it with the 3-band EQ, you can bring out more attack information if needed, as well as extra bottom below 80Hz.

Solid construction and hum elimination
Built like a tank with a 16-gauge steel chassis and powered by either a single 9V battery or a regulated DC power supply, the SFX-06 features a balanced XLR output with ground lift to eliminate electromagnetic interference and AC-hum. Between that and its active electronics you can drive longer cable runs to a feed a front-of-house mixing board or a recording console without noise or signal loss.

Gain Range: +/- 12dB
Input Impedance: 1MOhm
Output Impedance: 2KOhm
Maximum Output before Clipping: 2.6Vrms
Noise and Hum: -92dBV
THD at 1Vrms out at 1 KHz: 0.002 percent
Circuitry: FET Input OP-Amps with Discrete Gyrators
Power: DC 9 ” 12V; Battery or Regulated DC Adapter
Current Consumption: 2.9 mA Max
Dimensions: 5.5 x 5.2 x 2.2 inches
Weight: 1.9 Lbs
Chassis Material: 16 Gauge Steel
EQ Center Frequencies: Bass - 30Hz, Mid - 650Hz, Treble - 5.2KHz
Slap Contour Frequencies: +6dB at 80Hz, -6dB at 650Hz

post id: 7748443444



best of [?]