loading
reading
writing
saving
searching
WHEEL - $7 (BRONX)
4000 Boston Road near Dyre Ave
QR Code Link to This Post
These are the important measurements to know if this wheel is right for you:
The hole at the center is 1/4" in diameter. (This is the hole used to slide the wheel onto the axel.)
The width of the wheel at it's center (at the hole) is almost 1 1/2".
So, your axel must have about 2" for this wheel, the washers that are on each side of the wheel, and what holds all three on the axel.
The total width of this wheel is 1 7/8", including the black rubber.
This wheel is 7 3/4" in diameter. Make sure there is more than 4" from the axel to whatever the black rubber may touch, so the wheel will spin.
Additional information:
The black rubber is solid, not air filled.
The gray part of the wheel is steel.
The gray, steel part sticks out of one side of the wheel, but not the other side.
The center has contained ball-bearings.
This wheel is used, but in good, solid condition.
There are no cracks or breaks in it.
I only have this one.